Which tools are NOT acceptable for use in de-energizing or locking out energy sources during HECP lockout/tagout?

What tools should be avoided when de-energizing, locking, or tagging out energy sources in a Hazardous Energy Control Procedure (HECP) lockout/tagout? The tools that are not suitable for use in a Hazardous Energy Control Procedure lockout/tagout are Bungee cords, Push sticks, Tie backs, Jack stands, and Jumper wires. The only acceptable tool in the list is a Group lock box.

Avoiding Unsafe Tools in HECP Lockout/Tagout

When following a Hazardous Energy Control Procedure (HECP) lockout/tagout, it is crucial to use appropriate tools to ensure safety and effectiveness. Using the wrong tools can lead to accidents and injuries, so knowing which tools to avoid is vital.

1. Bungee cords: Bungee cords are not suitable for securing energy sources during lockout/tagout procedures. They lack the necessary strength and reliability to safely keep energy sources de-energized.

2. Push sticks: Push sticks are tools commonly used in woodworking to guide material through machinery. However, they are not designed for lockout/tagout purposes and should not be used to secure energy sources.

3. Tie backs: Tie backs may not provide a secure enough method of holding energy sources during lockout/tagout. They are not specifically designed for this purpose and should be avoided.

4. Jack stands: Jack stands are used to support vehicles or heavy equipment during maintenance. While they are sturdy, jack stands are not intended for locking out energy sources and should not be used for HECP procedures.

5. Jumper wires: Jumper wires are typically used in electronics to connect two points. They are not suitable for de-energizing or locking out energy sources in HECP lockout/tagout and should be avoided.

6. Group lock boxes: In contrast to the above tools, a group lock box is an acceptable tool for HECP lockout/tagout. It provides a centralized and secure point for padlocks and keys to keep equipment unavailable during maintenance or servicing.

← Welding assemblers the key to successful welding operations Creating three point saddle bends in conduit a reflective guide →

More Posts: